A furnace start is a chain of proofs. The thermostat calls. The inducer motor runs and a pressure switch proves the vent is clear. The igniter heats or sparks. The gas valve opens. The flame sensor proves flame within seconds or the valve closes. The blower waits for warm air, then delivers it. Clicking without heat is one link failed, and the technician's job is finding which link, in order, with a meter.
The no-heat guide in Costa Mesa is written for first-generation furnaces: igniter and flame sensor first, in the safety order, then the blower, and the heat exchanger as the verdict finding. In Mesa Verde and College Park stock, add one line: if the furnace is original to the house, the guide's last page is a replacement comparison, and the honest firm will price it in the same visit rather than selling a third repair into a finished system.
The common failed links, roughly by frequency: a flame sensor filmed over with oxide (cleaning or a modest part), a cracked hot surface igniter, a failing inducer, a clogged condensate trap on high efficiency units that mimics bigger faults, and control boards at the expensive end. Filters starve airflow and cause the overheating shutdowns that look like random failures.
The safety lines outrank the sequence. Gas or rotten egg smell: leave, then the utility or 911. A carbon monoxide alarm sounding: the same. A cracked heat exchanger is the finding that ends a furnace's life for safety reasons, and any technician who finds one will shut the system down and show you the evidence. That is not a sales tactic; it is the rule the trade works under.
Prefer to talk later? Leave your details and an independent local pro will call you back. No charge to you, no obligation.
Mesa Verde Heating and Air is a free referral service. Submitting this form connects you with independent local contractors who provide the work.